32
OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.
1. FITTING THE SANDING PAPER (SEE FIG A)
FIT THE SANDING PAPER
This sander features an easy hook and loop
accessory fastening system for quick changing
without clamps.
The sanding papers are placed directly onto the
base plate. The hole pattern in the base plate
and sanding paper must match. Then press
the sanding paper onto the base plate by hand.
Firmly press the power tool with the sanding
paper against a flat surface and briefly switch the
power tool on. This provides for good adhesion
and prevents premature wear
Before placing on the sanding paper, free the
base plate from dust/debris by lightly tapping
against it.
REMOVE THE SANDING PAPER
Simply remove the sanding paper directly.
A
2. USING THE Dust Collection BOX (SEE FIG
B)
A) ATTACH THE DUST BOX
Your sander is equipped with a Dust Collection
Box (5), which is designed for collect dust task.
Insert the Dust Collection Box into the rear dust
outlet of sander. Then pull the Dust Collection
Box and make sure it is tightened securely on the
dust outlet. (See Fig B)
B) EMPTY DUST BOX
For more efficient operation, empty dust box
every 5-10mins. This will permit the air to flow
through the box better.
To empty the dust box, pull off the dust box out
of the dust extraction outlet directly and shake
out dust.
B
3.USING THE DUST OUTLET (SEE FIG C)
Your sander is equipped with a 35mm dust outlet,
which are designed for connecting the hose of a
vacuum cleaner.
If the vacuum hose is 35mm, insert the hose
directly into the rear dust outlet of sander.
First please turn on the vacuum cleaner, and
then turn on the sander. If you stop sanding,
first turn off the sander, and then turn off your
vacuum cleaner.
Note:
Please pull the dust adapter to make sure
tightened securely on the dust outlet.
C
4. OPERATING THE On/Off SWITCH (SEE FIG
D)
To start your sander, depress the protective
cover over the switch at the position marked ”I”.
To stop your sander, depress the protective cover
at the position marked “0”
