48
B1
B2
OPERATION
1. GUARD ADJUSTMENT (SEE FIG. C)
Before any work on the machine itself,
remove the battery pack from your tool.
For work with grinding or cutting discs, the
wheel guard must be mounted.
Wheel Guard for Grinding
Open the clamping lever (a). Place the wheel
guard with coded projection into the coded
groove on the spindle of the tool head and rotate
to the required position (working position).
To fasten the wheel guard, close the clamping
lever (a).
The closed side of the wheel guard must always
point to the operator.
NOTE:
With the clamping lever (a) open the
clamp adjusting nut (b) can be adjusted to
ensure the guard is securely clamped after the
clamping lever (a) is finally closed.
Wheel Guard for Cutting
Warning!
For cutting metal, always work
with the wheel guard for cutting.
The wheel guard for cutting is mounted in the
same manner as the wheel guard for grinding.
C
2. INSTALLING AND ADJUSTING AUXILIARY
HANDLE (SEE FIG. D)
You have the option of two working positions
to provide the safest and most comfortable
control of your angle grinder. The handle can be
screwed clockwise into either hole on the sides
of the gear case.
NOTE:
this handle should be used at all times to
maintain complete control of the tool.
3. FITTING THE DISCS (SEE FIG. E1-E3)
Put the inner flange onto the tool spindle. Ensure
it is located on the two flats of spindle (see E1).
Place the disc on the tool spindle and inner
flange. Ensure it is correctly located. Fit the
threaded outer flange making sure it is facing
in the correct direction for the type of disc fitted.
For grinding discs, the flange is fitted with the
raised portion facing towards the disc. For
cutting discs, the flange is fitted with the raised
portion facing away from the disc (see E2).
Press in the spindle lock button and rotate the
spindle by hand until it is locked. Keeping the
lock button pressed in, tighten the outer flange
with the spanner provided. (See E3)
Note:
After mounting the grinder tool and
before switch on, check that the grinding tool is
correctly mounted and that it can be turn freely,
make sure that the grinding tool does not graze
against the protecting guard or other parts.
E1
a
b
D
