35
6. HAMMER DRILL FUNCTION (See Fig. E1,
E2)
1. Adjust the hammer or chisel action selector to
position “
“. (See Fig. E1)
2. Adjust the hammer or drilling action selector to
position “
“ . (See Fig. E2)
3. You are now set up for hammer drilling into
masonry.
Note: Press the selector switch lock button
before adjusting the dial selector everytime.
E1
E2
7. DRILLING FUNCTION (See Fig. F1, F2)
1. Adjust the hammer or chisel action selector to
position “
“ .(See Fig. F1)
2. Adjust the hammer and drilling action selector
to position “ “ .(See Fig. F2)
3. You are now set up for drilling function.
NOTE:
Press the selector switch lock button
before adjusting the dial selector everytime.
F2
F1
F2
F1
8. CHISEL FUNCTION (See Fig. G1, G2)
1. Adjust the hammer and chisel action selector
to position “ “ .(See Fig. G1)
2. Adjust the hammer and drilling action selector
to position “
“ .(See Fig. G2)
3. You are now set up for chisel work using chisel
action.
Note: Press the selector switch lock button
before adjusting the dial selector everytime.
WARNING:
You must make sure that the
selector switch is positively locked in chisel
mode position. If not, it could cause a hazard.
G1
G2
Summary of Contents for R-ME1500
