36
(D1).
Now fit the top saw blade (B) with the closer
together holes on the saw blade mounting. The
saw blade must fit perfectly in the mounting (D2).
Fit the clamping screw again and tighten it by
hand (D3).
Press the Spindle Locking Button(1). Turn the
blades in opposite directions until they lock.
Tighten the clamping screw by turning it
clockwise using the Spanner(7) supplied.
Carefully turn the saw blades by hand to ensure
that they have been fitted correctly.
NOTE:
Never use blunt saw blades since this
could result in their teeth being damaged.
Replace blunt saw blades without delay.
WArNING!
i. Keep the saw blades clean and sharp
at all times. Ensure that the saw blades are
fitted correctly. A blunt saw blade will reduce the
cutting capacity, place additional strain on the
saw’s motor and increase the risk of recoil.
ii. Ensure that you always have spare saw
blades available. In the event that resin and
pitch residue get on to the saw blade, the blade’s
speed will be reduced.
iii. Remove these residues straight away using
special resin removal products, hot water or
kerosene.
iv. Never use petrol to remove these residues.
Never use normal saw blades in this saw. This
twin blade saw is fitted with specially designed
saw blades. The use of other saw blades is not
permitted and may result in very serious injuries.
opeRation
1. SAFETy ON/OFF SWITCH
Push the ON/OFF switch forwards to switch on
the saw. Release the ON/OFF switch again to
switch off the saw.
NOTE:
After you have switched on the saw,
wait until the saw blades have reached their top
speed before you place them on the workpiece.
If the saw blades are brought into contact with
the workpiece before they have reached their
top speed, this can result in recoil and serious
injuries.
IMpOrTANT!
When you want to stop the
machine, you should keep the machine away
from the workpiece first, and then you can
release the ON/OFF Switch to turn off the
machine.
2. CrOSS CuTTING (See E1)
Aluminum, copper, stainless steel, cast iron
The lubrication device must always be used for
cutting these materials.
Flat bar iron (See E2)
Position the saw blade perpendicular to the
cutting surface.
Corner pieces (See E3)
30 mm
A1
A2
B
C1
C2
C3
D1
D2
D3
E1
E2
E3
E4
E5
E6
E7
E8
E9
