V02 en, SCC_WE
- 62 -
Gas Error Logger Burner Control 0
Indication of the last 14 gas-failures, generated by ignition box top)
Gas Error Logger Burner Control 1
Indication of the last 14 gas-failures, generated by ignition box bottom)
Indication of ignition box error messages (1-32 is shown to the operator as „Reset“):
1
Hot air or Steam
no gas, gas valve or electrode defective
14
Hot air
gas valve control, change ignition box
19
Hot air
no flame because flame current is too low
check burner setting, flame current, ignition cable and plug
20
Hot air
wrong or no rpm signal from gas blower
check gas blower, power supply gas blower and control harness
of gas blower
22
Hot air
no flame after 5 ignition sequences
no gas, gas valve or electrode defective
24
Steam
gas valve control, change ignition box
29
Steam
no flame because flame current is too low
check burner setting, flame current, ignition cable and plug
30
Steam
wrong or no rpm signal from gas blower
check gas blower, power supply gas blower and control harness
of gas blower
32
Steam
no flame after 5 ignition sequences
no gas, gas valve or electrode defective
Possible failure in case of „Service 32“
33, 36
Change ignition box
35
Check frequency of main
38
CPU does not send any or correct rpm signal to ignition box; Switch unit off and
on or run repair program for SD Card (SCC_WE) or EEPROM (CM_P)
39
Hot air
Check burner setting, ignition electrode and distance,
and flame current
40
Hot air
Check ignition cable
42
Steam
Check burner setting, ignition electrode and distance,
and flame current
43
Steam
Check ignition cable
Is shown on display „Change polarity“
34
Change polarity of mains
All other numbers (2-14, 21, 23, 25-28, 31): change ignition box
Download of gas error data
Summary of Contents for SCC_WE
