7
Coin counting
Switch on machine and wait until the self-test is complete and
0.00
appears in the display.
Feed the coins into the coin funnel.
Press the
START / STOP
key to start the counting process.
Press the
START / STOP
key again to stop the counting process. The machine automatically switches
itself off after 20 seconds without coin infeed. The sum total in Euro is shown in the display.
In order to view the number of individual coin types, press the
Report
key.
Use the
C
key to return to the counting result.
In order to continue with the counting process, feed in more coins and press the
START / STOP
key.
The machine stops automatically if a coin container is full.
In order to start a new count, empty the coin container and reset the counter to
0.00
using the
C
key.
Batch mode
When the Set key is pressed, the preset number for the individual coin types is displayed.
Default settings:
Use the +/- keys to increase or decre-
ase the respective preset numbers in
steps of 1. The Bat key can be used to
change the respective preset quanti-
ty in larger steps. If one of the preset
quantities is attained during a counting process, the machi-
ne stops automatically and shows which coin type is affec-
ted and how many coins are situated in the respective tray.
Remove the coins from the affected tray and continue with
the counting process by pressing the START / STOP key.
€
0,10
–
110
€
0,05
–
110
€
0,02
–
150
€
0,01
–
150
€
2
–
80
€
1
–
80
€
0,50
–
80
€
0,20
–
110
Troubleshooting
Should a coin get stuck in a coin duct,
switch off the machine. Pull the po-
wer plug and remove the remaining
Error messages
EC
–
Rotary disc error / no rotation
E0
–
Coin recognition error
E1 – E8
–
Sensor error for the respective slot number counted from the right.
coins from the machine. Remove the stuck coins by hand or
with another suitable object by reaching into the coin duct
from below.
The following error messages could appear on the display following the self-test after the machine
is switched on.
1
2
3
4
5
6
7
8
9
