PART 3
Assembly instruction
1.
Put the fork stem into head tube.
2.
Put the spacer as the photo, step1 plastic spacer step2 silver spacer step3 alloy
cover
3.
Note: put the step1 plastic spacer inside the gap; make sure the fork tube cannot move
4.
Step4 alloy 3*10mm spacer.
5.
Put the stem inside the fork tube.
6.
Tighten the screw by the Allen key.
7.
Tighten the screw by the Allen key.
8.
Make sure no gap between the headset and the fork crown.
9.
Put the front wheel on the fork arch and quick release into the hub as the photo, same
direction.
10.
Tighten the screw on the another side.
11.
Put the pedal inside the crank hole, please make correct on left and right side.
12.
Tighten the screw by the wrench.
13.
Do not pass the safety line on the seat post when you rise the saddle.
