Instructions for Use MPR1 DATALOGGER
Manufacturer:
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany
Page 45 of 98
4.4.3.2 Changing limiting alarm value settings for invasive pressure measurement
On the example of the ICP, reset the limiting values. The settings of the limiting values of the other ICPA
and CPP measured values are carried out correspondingly.
Parameter
Range with alarm limits
Alarm activation
Key for conventional
zeroing.
Press Menu key, if you want
to modify the marked field
Do not set the limiting values to extreme values which could render the alarm system useless.
4.4.3.2.1 Changing the pressure limiting value
Increasing the lower limiting value:
Keep the UG+ key pressed until
the requested value is reached.
Lowering the upper limiting value:
Keep the OG- key pressed until
the requested value is reached.
Leave the window by pressing OK,
if no other changes are required.
You will now access the overview
of the measured values. The new
limiting values will be displayed,
provided Yes has been activated
for the parameter Active.
If you want to change other settings or repeat a setting, press the ICP1 key or the key of another measuring
location again.
This
document
is
for
information
only
