GB
Page 50 of 64
INSTRUCTION, USE AND
MAINTENANCE MANUAL
When the device is enabled, this is shown by a “mark
off”, see example below:
Rim width automatic
measuring device EN-
GAGED
→
Rim width automatic
measuring device DIS-
ENGAGED
→
THE AUTOMATIC DISTANCE AND
DIAMETER MEASURING DEVICE
IS ALWAYS STANDARD. IT MUST
ONLY BE DISABLED IN CASE OF
FAULTS.
At the end press key “F1”
to exit.
20.4 Lower weight limit
Correction weight below a certain limit is normally
shown equal to zero. This limit can be set from 10 g
to 1 g.
At the end of the spin however, by pressing the key
(see example
Fig. 50
), the weight can be
displayed with max resolution of 1g, not considering
the set lower limit.
To change the resolution and lower limit, from the
opening presentation page (see
Fig. 33
), press the
“F1 key”
; the program will display the page
in
Fig. 96
.
Press the “F2 key”
. Enter password
F1-F2-
CENTR-F3
to access the “customer configuration”
screen page (see
Fig. 98
).
From the "client configuration" page, press
5 succes-
sive times
the "F4 key"
, the program will
show the following screen page:
Fig. 103
4
KEY
1 – Lower weight limit setting (5 g) for dynamic
wheel balancing mode
2 – Lower weight limit setting (7 g) for ALU (all
types) PAX and STATIC modes (all types)
3 – Selection line
4 – Return to
Fig. 96
screen page (RED) (F1)
5 – Move the selection line under the resolution or
lower limit value (YELLOW) (F2)
6 – Change the selected values with the selection
line (CENTRAL)
7 – Return to
Fig. 98
customer configuration
screen page (GREEN) (F4)
6
7
2
5
1
3
G2.124R - GP2.124R
RAVAGLIOLI S.p.A.
1297-M010-0_R
