Page 14 of 37
INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
10.1 Working area modification
After the delivery, the machine is prearranged to op-
erate on wheel of 50” maximum diameter and a rim
diameter (10” - 30”). It’s also possible to move the tools
column to enlarge the working area from 52” (with rim
diameter of 12” - 32”) up to 54” (with rim diameter of
14” - 34”) (see
Figure 12
).
Fig.
_
11
A
B
The column is moved by unloosing the fixing screws of
the base (
Fig.
_
11 ref.
_
A
) to the column (
Fig.
_
11 ref.
_
B
)
and by sliding the base (
Fig.
_
11 ref.
_
A
) itself into the
proper slots until the required measure.
MAKE SURE THE TYRE-CHANGER
COLUMN IS STABLE: USE A CA-
BLE, HELD BY A HOIST.
1. Remove the lateral guards (
Fig.
_
12 ref.
_
1-2
) of the
machine.
2. Unscrew the screws (
Fig.
_
12 ref.
_
3
) and the nuts
near the central slots (
Fig.
_
12 ref.
_
4
) paying atten-
tion not to remove the nuts from the proper screws.
3. Remove the six remaining screws (
Fig.
_
12 ref.
_
5
).
4. Move the base (
Fig.
_
12 ref.
_
6
) into the required
position (to 43” or 45”) and if necessary, use a lift-
ing device.
5. Lock the base three screws (
Fig.
_
12 ref.
_
3
) with a
couple of 80 Nm.
6. Place six screws (
Fig.
_
12 ref.
_
5
) previously removed
and lock them on the bases side with a couple of
80 Nm.
7. Assemble again the lateral guards (
Fig.
_
12 ref.
_
1-2
)
of the machine.
FIT A TYPE-APPROVED PLUG
TO THE MACHINE CABLE (THE
GROUND WIRE IS YELLOW/GREEN
AND MUST NEVER BE CONNECT-
ED TO THE PHASE LEADS).
MAKE SURE THAT THE ELECTRI-
CAL SYSTEM IS COMPATIBLE
WITH THE RATED POWER AB-
SORPTION SPECIFIED IN THIS
MANUAL AND APT TO ENSURE
THAT VOLTAGE DROP UNDER
FULL LOAD WILL NOT EXCEED
4% OF RATED VOLTAGE (10%
UPON START-UP).
VERSION WITH
SINGLE-PHASE MOTOR
On delivery, the machine is pre-set to operate at a
single-phase voltage of 200 ÷ 265 V - 50/60 Hz.
FAILURE TO OBSERVE THE ABOVE
INSTRUCTIONS WILL IMMEDIATE-
LY INVALIDATE THE WARRANTY.
G1180.30SLIM - G1180.30SLIMIT
7105-M002-10_R
RAVAGLIOLI S.p.A.
