Page 15 of 37
INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
11.0 CONTROLS
A
B
C
E
D
F
F2
F1
G
G2
G1
H
I
L M
Fig.
_
13
11.1 Control device
The control device consists of a panel with integrated
keys and push buttons.
•
Inflation pressure gauge
“A”
for tyre pressure readout.
•
Inflation push button
“B”
when pushed allows to
deflate the tyre at the required pressure.
•
Lever
M
, through a thrust and return movement,
together with
L
unlocking push button, enables tools
setting on wheel diameter.
•
Unlocking push button
L
must be pushed before
operating lever
M
for arms positioning. Releasing
the push button, the arms lock into the set position.
ATTENTION: push button
L
must be pressed before
operating lever
M
otherwise the lever does not allow
any movement.
Panel
C
consists of:
• Push button
“D”
has one maintained action position
and once pushed it controls the operation of the cam
for the insertion of the upper bead breaking roll into
the rim.
• Push button
“E”
has one maintained action posi-
tion and once pushed it controls the operation of
the cam for the insertion of the lower bead breaking
roll into the rim.
AFTER THE ASSEMBLY, CHECK
THE CORRECT POSITION OF THE
TOOLS. LOCK THE RIM ON THE
MANDREL CENTRE. WITH THE
BEAD BREAKER ARM, CHECK
THAT THE DISTANCE BETWEEN
THE ROLL AND THE RIM EDGES
(UPPER AND LOWER) IS THE
SAME. REPEAT ALL THE PROCE-
DURES STARTING FROM POINT
1 IF THE DISTANCE IS NOT THE
SAME.
1
2
3
3
5
6
3
5
4
4
43" 41"
45"
5
Fig.
_
12
10.2 Electrical checks
BEFORE STARTING UP THE TYRE-
CHANGER, BE SURE TO BECOME
FAMILIAR WITH THE LOCATION
AND OPERATION OF ALL CON-
TROLS AND CHECK THEIR PROP-
ER OPERATION (SEE PAR. “CON-
TROLS”).
CARRY OUT A DAILY CHECK OF
MAINTAINED-TYPE CONTROLS
CORRECT FUNCTIONING, BEFORE
STARTING MACHINE OPERATION.
7105-M002-10_R
RAVAGLIOLI S.p.A.
G1180.30SLIM - G1180.30SLIMIT
