Page 25 of 37
INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
• Remove deposits of tyre powder and other waste
materials with a vacuum cleaner.
DO NOT BLOW IT WITH COMPRESSED AIR.
• Do not use solvents to clean the pressure regulator.
• The conditioning unit is equipped with an automatic
vacuum-operated drain therefore it requires no
manual intervention by the operator (see
Fig.
_
44
).
• Periodically check the calibration of the lubricator
of the pressure regulator/oiler unit: 1 oil drop every
11-15 revolutions of self-centring chuck motor.
1
PRESSURE REGULATOR
DEPRESSURE RELEASE
SEMI-AUTOMATIC
OILER
AIR
SUPPLY
Fig. 44
IN ORDER TO ENSURE A GOOD
FUNCTIONING AND TO AVOID THE
PRESENCE OF CONDENSATION
IN THE AIR TREATMENT UNITS
WITH SEMI-AUTOMATIC DRAIN,
IT'S NECESSARY TO MAKE SURE
ABOUT THE CORRECT POSITION
OF THE VALVE (FIG. 44 REF. 1),
PLACED UNDER THE CAP. TO
ACTIVATE A CORRECT DRAIN
FUNCTION, THE CAP MUST BE
ROTATED IN THE RIGHT WAY.
IN ORDER TO ALLOW A LONGER
LIFE OF THE FILTER AND OF ALL
MOVING PNEUMATIC DEVICES,
YOU HAVE TO MAKE SURE THAT
THE SUPPLIED AIR IS:
• EXEMPT FROM THE LUBRICAT-
ING OIL OF THE COMPRESSOR;
• EXEMPT FROM HUMIDITY;
• EXEMPT FROM IMPURITY.
• Periodically, with a frequency of at least once a month,
lubricate the arms of the bead breaking roller and
of the tools.
• Immediately replace worn parts, bead breaking roller,
assembly tools.
• Every
week
and/or when necessary, top up the oil
tank using the filler hole provided, closed by a cap
or screw, on the lubricator filter.
NOTE: This operation should not be carried out
by unscrewing the cup of the lubricator filter.
• The use of synthetic oil might damage the pressure
regulator filter.
• Immediately replace worn parts, bead breaking roller,
assembly tool.
• Periodically (at least every 100 working hours) check
reduction gear lubricating oil level (
Fig.
_
45 ref.
_
5
).
Such operation must be effectuated unscrewing the
screws (
Fig.
_
45 ref.
_
1
), removing the flange (
Fig.
_
45
ref.
_
2
), the guard (
Fig.
_
45 ref.
_
3
) and the plug
(
Fig.
_
45 ref.
_
4
) on the reduction gear.
1
4
5
1
2
3
Fig. 45
ANY DAMAGE TO THE MACHINE
DEVICES RESULTING FROM THE
USE OF LUBRICANTS OTHER
THAN THOSE RECOMMENDED
IN THIS MANUAL WILL RELEASE
THE MANUFACTURER FROM ANY
LIABILITY!!
7105-M002-10_R
RAVAGLIOLI S.p.A.
G1180.30SLIM - G1180.30SLIMIT
