Brochure for models with FLASH motherboard
( firmware version ECT2008air - & ECT2008box - )
PAGE
2.7 “CLOCK setting“ menu
to set the clock, proceed as follows:
1. Keep button p4 pressed for 2 seconds, MenU 01 set CLOCK will appear and confirm with p6.
2. DaY will appear: with buttons p4 and p5 set the current day according to the table shown below and confirm with button p6.
Message
Display showing
01
Monday
02
tuesday
03
Wednesday
04
thursday
05
Friday
06
saturday
07
sunday
OFF
Day excluded
3. hOURs will appear on the display and the current time will be shown: with buttons p4 and p5 set the hours and confirm with
p6.
4. MinUtes will appear on the display, with buttons p4 and p5 set the minutes and confirm with p6.
5. Confirming with p6 key, it automatically return to the 01 set CLOCK MenU.
14
2.8 “ChROnOtheRMOstat setting“ menu
With the chronothermostat function, switching on and off the stove for each day of the week can be programmed in two
independent time intervals (pROgRaM 1 and pROgRaM 2).
to enter this menu, proceed as follows:
1. Keep button p4 pressed for 2 seconds, CLOCK setting MenU will appear.
2.press key p4 once : the screen will display MenU 02 set CROnO.
3. access with key p6 : the display will show the desired screen.
DesCRiptiOn OF the stRings:
Description
Values that can be set
staRt pROg – 1
From OFF to 23:50 in 10’ steps
stOp pROg – 1
From OFF to 23:50 in 10’ steps
Day pROg – 1
Between on/off for days from Monday to sunday
pOWeR pROg – 1
From 01 to 05
set taMB pROg – 1
From est,07°C/45 F,08°C/47 F.......to Man
staRt pROg – 2
From OFF to 23:50 in 10’ steps
stOp pROg – 2
From OFF to 23:50 in 10’ steps
Day pROg – 2
Between on/off for days from Monday to sunday
pOWeR pROg – 2
From 01 to 05
set taMB pROg – 2
From est,07°C/45 F,08°C/47 F....... to Man
staRt pROg: this parameter shows the time pROgRaMs 1 and 2 are switched on.
stOp pROg: this parameter shows the time pROgRaM 1 and 2 are switched off.
Day pROg: this parameter is used to set the days on which you wish to activate program 1 and 2. to set this parameter, proceed as
follows: set the required day (the days are Monday, tuesday…) with button p5 and with button p4 select the value On-OFF: if OFF
is set programming will not be activated on the desired day, if On is set the programming will be valid. after the programming
operation, press p6 and go on to the next parameter.
pOWeR pROg: this parameter is used to indicate the stove’s power when it is switched on with CROnO.
teMpeRatURe pROg: this parameter is used to indicate the ideal temperature you wish to reach in the room where the stove is
installed during start with CROnO active. the setting in question is overwritten on top of the one set in manual work conditions.
