Use and maintenance manual Touch Radio Hydro
Pag.33
Rev.0 18/05/2021
EN
Diagram 2 (buffer tank sensor)
1. Indicates the water temperature of the storage puffer that you want to reach (if the thermostat is connected to the puffer, it indi-
cates whether it requires heating the domestic water with ON t.ext. Or not with OFF t.ext.);
2. Icon indicating the status of the stove;
3. Indicates the temperature of the water in the thermo stove.
It is possible to change the puffer water temperature set by touching the UP arrow key. In this way this part of the display is highlighted
and the currently set temperature is shown. With the UP and DOWN arrow keys it is possible to modify this value. The confirmation
of each change takes place automatically within 3 seconds of the change or by pressing the confirmation button. An acoustic signal
certifies the change.
It is not possible to change the water temperature in the thermo stove.
Diagram 3 (boiler buffer tank sensor)
1. Indicates the temperature of the DHW tank to be maintained (if the thermostat is connected to the tank, it indicates whether it
requires heating the domestic water with ON t.ext. or not with OFF t.ext.);
2. Icon indicating the status of the stove;
3. Indicates the water temperature of the storage puffer that you want to reach (if the thermostat is connected to the puffer, it indi-
cates whether it requires heating the domestic water with ON t.ext. Or not with OFF t.ext.)
It is possible to change the DHW temperature set by touching the UP arrow key. In this way this part of the display is highlighted
and the currently set temperature is shown. With the UP and DOWN arrow keys it is possible to modify this value. The confirmation
of each change takes place automatically within 3 seconds of the change or by pressing the confirmation button. An acoustic signal
certifies the change.
It is possible to change the puffer water temperature set by touching the DOWN arrow key. In this way this part of the display is
highlighted and the currently set temperature is shown. With the UP and DOWN arrow keys it is possible to modify this value. The
confirmation of each change takes place automatically within 3 seconds of the change or by pressing the confirmation button. An
acoustic signal certifies the change.
Quick status display
From the Home screen, by touching the CONFIRM key it is possible to view some parameters measured by the stove control unit.
The displayed parameters changes according to the set pattern.
•
POWER: indicates the power of the stove, which can be:
- MIN: operation at minimum power;
- MAX: operation at maximum power;
- MOD: modulation of the stove with settings reached;
- SANI: if the rapid DHW kit is present, as soon as there is a request for domestic hot water, the stove switches to domestic
power autonomously;
•
PUMP: indicates whether the pump is on or off;
•
3-WAY VALVE: indicates whether the three-way valve is in the HEATING, SANITARY, PUFFER or BOILER position;
•
PRESSURE: indicates the water pressure in the stove.
•
REMOTE CTRL TEMPERATURE: temperature detected by the handheld remote control
2
1
3
2
1
3
Summary of Contents for Hydro
