32
Page 18
8.3 Warranty Exclusions
This warranty does not cover the following:
• Changes in surface finishes as a result of normal use.
As a heating appliance, some changes in colour of
interior and exterior surfaces may occur. This is not a
flaw and is not covered under warranty.
• Damage to printed, plated, or enamelled surfaces
caused by fingerprints, accidents, misuse, scratches,
melted items, or other external sources and residues
left on the plated surfaces from the use of abrasive
cleaners or polishes.
• Repair or replacement of parts that are subject to
normal wear and tear during the warranty period.
These parts include: paint, gaskets, FIREX, flame
guides, and the discolouration of glass.
• Minor expansion, contraction, or movement of certain
parts causing noise. These conditions are normal and
complaints related to noise are not covered by this
warranty.
• Damages resulting from: (1) failure to install, operate
or maintain the pellet fire in accordance with the
installation instructions, operating instructions and
data plate furnished with the pellet fire; (2) failure to
install the pellet fire in accordance with local building
codes; (3) shipping or improper handling; (4) improper
operation, abuse, misuse, continued operation with
damaged, corroded or failed components, accident,
or improperly/incorrectly performed repairs; (5)
environmental conditions, inadequate ventilation,
negative pressure, or drafting caused by tightly sealed
constructions, insufficient make-up air supply, or
handling devices such as exhaust fans or forced air
furnaces or other such causes; (6) use of fuels other
than those specified in the operating instructions;
(7) installation or use of components not supplied
with the pellet fire or any appliance not expressly
authorised and approved by Pellet
Ravelli
it
u
l
o
S
/
on
e
ri
F
s
; (8) modification of, interruptions to or
fluctuations of the electrical power supply to the pellet
fire.
• Non Pellet
Solution
e
ri
F
s approved venting
components, hearth components or other
accessories used in conjunction with the appliance.
• Any part of a pre-existing fireplace system
• Pellet
Ravelli
it
u
l
o
S
on
e
ri
F
s
r
e
d
n
u
n
o
it
a
g
il
b
o
s
/
’
this warranty does not extend to the pellet fires’
capability to heat the desired space. Information is
provided to assist the consumer and the dealer in
selecting the proper appliance for the application.
Consideration must be given to appliance location and
configuration, environmental conditions, insulation and
air tightness of the structure.
The warranty is void if:
The pellet fire has been over-fired or operated in
atmospheres contaminated by chlorine, fluorine, or other
damaging chemicals. Over firing can be identified by, but
not limited to, warped plates or tubes, rust coloured cast
iron, bubbling, cracking and discolouration of steel or
enamel finishes.
The pellet fire is subjected to prolonged periods of
dampness or condensation.
There is any damage to the pellet fire or other components
due to water or weather damage which is the result of, but
not limited to, improper chimney or venting installation.
The owner’s exclusive remedy and Pellet
Ravell
it
u
l
o
S
i
ons
e
ri
F
/
’s sole obligation under this
warranty, under any other warranty, express or
implied, or in contract, tort or otherwise, shall be
limited to replacement, repair, or refund, as specified
above. In no event will Pellet
Ravell
it
u
l
o
S
i
on
e
ri
F
s /
be liable for any incidental or consequential
damages caused by defects in the appliance. Some
countries do not allow exclusions or limitation of
incidental or consequential damages, so these
limitations may not apply to you. This warranty
righ
t
o
,
s
t
her
ha
ir
u
o
y
y
a
m
o
s
l
a e
v
gh
s
,
s
t
pe
u
o
y
c
if
i
c
s
e
v
i
g
which vary from country to country. EXCEPT TO THE
EXTENT PROVIDED BY LAW, Pellet
Ravelli
Solution
e
ri
F
s /
MAKES NO EXPRESS WARRANTIES OTHER
THAN THE WARRANTY SPECIFIED HEREIN.
ABOVE.
SPECIFIED
WARRANTY
EXPRESSED
F
O
E
H
T
DURATION
O
T
S
I
D
E
T
I
M
I
L
WARRANTY
Y
N
A
D
E
I
L
P
M
I
DURATIONOF
E
H
T
27
Summary of Contents for Pompeii
