Navigation Aid System Setup and Operation Manual
Page 16 of 21
9 Setup of Traffic Management System
The Raven Traffic Management System differs from the Raven Navigation Aid System in that it uses a
WAAS GPS receiver. This WAAS GPS receiver is a low-end, third-party, GPS receiver.
This system contains a third-party Bluetooth GPS receiver, a Raven BPI (Bluetooth Pilot Interface), and a
laptop computer. The GPS receiver is for use only when the AIS GPS is not available, and does not
provide the same accuracy as the sub-meter Raven GPS receivers.
Figure 14: Raven Traffic Management System
To use the iBlue 737 with the Raven Traffic Management System, do the following:
9.1 General Setup Steps
In general, the steps are:
1. Set up the computer and turn it on. You may apply 100-240 VAC power or use the internal laptop
battery.
2. Set up the GPS receiver as described in the next sub-section, 'Setup of Traffic Management GPS
Receiver'.
3. Setup the BPI, as described earlier in this document.
4. On the laptop computer, start the Raven navigation software, usually Wheelhouse II (WHII).
