7
Elevation Coarse Adjustment
: Slightly loosen the 5/16” X 3/4" UNC Carriage Bolts in the arched slots
at the bottom sides of the Elevation Bracket. Insert the handle as shown in (fig 7). Rotate the handle to
adjust the elevation until the approximate value supplied with the Work Order matches the elevation
setting. With the use of the inclinometer shelf, it is possible to coarsely elevate the antenna to the
desired setting.
Azimuth Coarse Adjustment:
Using the compass, set the antenna in the correct direction as listed on
the work order.
DO NOT USE THE REFLECTOR TO ADJUST THE AZIMUTH
Secure this position by tightening the three 5/16” serrated flange nuts on the three Carriage Bolts in
each of the holes in the Tube Canister flanges using a ½” wrench.
Figure 7
