8
Azimuth Fine Adjustment:
To fine adjust the Azimuth slacken the four 5/16” x 3/4" UNC Carriage
Bolts in the bottom of the Azimuth Base. Next, turn the 2 1/2" x 5/16” UNC Hex Cap Bolt through the
hole on the right side of the Azimuth Base to give you the azimuth angle you require. After verifying the
Azimuth with a compass and a meter, lock down the four 5/16” x 3/4" Carriage Bolts in the bottom of
the Azimuth Base to 20Nm (177 in.lbf) using a ½” socket and Torque Wrench, tightening opposing
corners uniformly (fig 8).
Elevation Fine Adjustment
: Make final adjustments to the elevation by rotating the handle, moving
clockwise and anti-clockwise will increase and decrease the setting respectively. After achieving the
correct elevation, tighten the 5/16” x 3/4" Carriage Bolts in the arched slots at the bottom sides of the
Elevation Bracket to 20Nm (177 in.lbf) to lockdown using a ½” socket and Torque Wrench. Once the
elevation is locked off, rotate and remove the handle, as shown in (fig 9).
Figure 8
Figure 9
