4
016-0236-001 Rev. C
29
SENSOR INSTALLATION
3. Using a provided 2-9/16” x 3-1/2” U-bolt, loosely install the rotary sensor strap bracket to the vertical tube on
the front side of the center rack. The short leg of the bracket will be pointing down on the left side of the
center.
FIGURE 7. Installed Rotary Sensor
4. On the center frame, use two provided 3-1/16” x 4” U-bolts to loosely install the rotary sensor assembly labeled
“Center Rack” to the lower horizontal tube positioned between the center rack and the center frame. The
sensor mounts on the right side of the center. The connector on the sensor will point down the left side of the
machine.
5. Install the rotary sensor link and rod end to the rotary sensor strap and secure with an M6 nylock nut.
NOTE:
The rotary sensor link should be installed so it is parallel to the ground.
6. Using two wrenches, secure the rotary sensor link.
7. Adjust the rotary sensor bracket and the rotary sensor strap until the rotary sensor arm is vertical.
8. Tighten all hardware.
Rotary Sensor
Rotary Sensor
Bracket
3 1/16” x 4”
U-Bolts
Rotary Sensor Link
Rotary Sensor
Strap
2 9/16” x 3-1/2”
U-Bolt
M6 Nylock Nut
