C
HAPTER
3
12
AutoBoom® XRT Installation Manual for Case IH Patriot 3XX0/44X0 and Trident 5550 (MY 2017-19)
INSTALL FITTINGS ON THE AUTOBOOM XRT VALVE
Before mounting the AutoBoom XRT valve on the machine, install the proper fittings in the valve.
Refer to the following table to install the fittings in the appropriate ports of the AutoBoom XRT valve:
REMOVE THE ORIFICE FITTINGS (FOR MACHINES WITH AUTOBOOM
ALREADY INSTALLED)
On machines with AutoBoom already installed, it is necessary to remove the existing AutoBoom node and
mounting plate as well as remove the orifice fittings in the AutoBoom valve. The AutoBoom valve will be reused
for the AutoBoom XRT installation.
1. Locate Ports 3A and 3B on the AutoBoom valve.
FIGURE 1. Port 3A and 3B Location
2. Remove the coils from the solenoids near Ports 3A and 3B to gain easy access to those ports.
Fitting
Part Number
Port
Fitting - -6 ORFS (M) to -8 SAE O-Ring (M) 90° Elbow
333-0012-165
LF CYL RTN,
RT CYL RTN
Fitting - -6 ORFS (M) to -6 SAE O-Ring (M) Straight Adapter
333-0012-084
LC, RC
Fitting - -8 ORFS (M) to -8 SAE O-Ring (M) Straight Adapter
333-0012-168
P, T
Fitting - -6 Hex 9/16” O-Ring Plug
333-0012-194
LV, RV
Port 3B
Port 3A
