C
HAPTER
3
16
AutoBoom® XRT Installation Manual for Case IH Patriot 3XX0/44X0 and Trident 5550 (MY 2017-19)
FIGURE 9. REM Node Installed
3. Secure the mounting bracket to the machine’s center rack using two 2-9/16” W x 3-1/2” L x 3/8” thread U-bolts
and four 3/8”-16 flange nuts.
INSTALL THE PRESSURE AND TANK HOSES
Refer to Figure 14 on page 20 while performing the following steps.
4. Disconnect the machine’s pressure hose from the machine’s hydraulic valve.
WARNING
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic fluid
within the machine’s system may be extremely
hot and under high pressure.
CAUTION
When installing hydraulics or performing
diagnostics, maintenance, or routine service,
ensure precautions are taken to prevent any
foreign material or contaminants from being
introduced into the machine’s hydraulic system.
Objects or materials that are able to bypass the
machine’s hydraulic filtration system will reduce
performance and possibly cause damage to the
hydraulic valve.
Installed REM Node
