016-0236-001 Rev. C
33
SENSOR INSTALLATION
5. Use the provided hardware to install the tilt sensor link to the tilt sensor arm. When the installation is complete
the tilt sensor arm should be perpendicular to the tilt sensor bracket.
6. Attach the other rod end to the rod end bracket with M6 nylock nut.
7. Tighten all hardware installation hardware.
8. Repeat step 1 through step 7 to install the left boom sensor.
PROXIMITY SENSOR
NOTE:
The following steps are not required for machines with 120’ boom configurations.
1. Install proximity sensors in the location shown in Figure 14 on page 33 (right side shown).
FIGURE 14. Proximity Sensor Mounting Location
2. Attach the proximity sensors to the existing bracket using a spacer and the M6 hardware provided (see
Proximity
Sensor
