Chapter 3
14
AutoBoom® Calibration & Operation Manual
To stop the calibration at any time, touch the stop calibration icon for the center section.
Note:
A calibration progress bar will display at the top of the tab. The calibration of the XT
Control feature may take up to a minute to complete. If the boom fails to calibrate, refer
to Chapter 5, Troubleshooting, and troubleshoot the system.
Boom tips may raise automatically during calibration to allow for full rotation of the center rack.
Pressure in slant cylinders will increase until the center section begins to rotate slightly. The center
section will then rotate fully clockwise and then counterclockwise to calibrate the center rotation
sensor position.
The center rotation sensor may be re-centered by recalibrating XT Control or by manual
adjustment of the centering bolt while the center section is confirmed to be in the center position.
AutoBoom
®
Settings Definition
AutoBoom
®
Features Tab
1.
Touch the Edit icon in the Machine Configuration panel to expand the panel.
2.
Locate and select the AutoBoom button. The AutoBoom Features tab will be displayed.
Note:
Most of the machine profile settings (boom size, spacing, etc) are completed during machine
configuration. Refer to the Basic ROS Operation manual for additional information on machine
configuration. Selecting a machine from the Machine Profile drop down will adjust some of the
tuning settings such as speed, stability, and the stability factor based on the selected machine.
These settings can be viewed in the Tuning tab.
System Type
(UltraGlide Systems) The system type selection allows the UltraGlide system to operate in PowerGlide Plus
mode. This mode requires gauge wheels to be installed on the booms and orifices removed from the
Stop
Calibration
Edit
AutoBoom
Features
UltraGlide Systems
Machine Profile
Drop Down
Tuning Tab