Manual No. 016-0130-076 Rev. C
29
Operation
PowerGlide Plus Joystick Interface Functions (Center Rack Control Feature Disabled)
The following joystick control interface functions are available when operating an AutoBoom PowerGlide Plus
system with the center rack control feature disabled.
Note:
Implement may require the activation of a boom valve and/or master switch before the center rack
control feature may be enabled.
Active center rack height control will not be enabled as this control feature is disabled.
Setting Transport Height.
Ultrasonic sensors will react to the first object that reflects an echo, whether it is
the ground or the crop canopy. Return to height and return to transport heights are sensor measurements
relative to the first reflected signal (e.g. crop canopy), not necessarily ground level.
To set the transport height to maximum center rack height:
1.
Raise the center rack above the current set transport height.
2.
Double up-tap on the center rack function switch. AutoBoom will save the maximum height as the new
transport height.
Note:
Four up-taps will also reset the transport height to the maximum center rack height as defined in
the above joystick interface function tables.
To set the transport height to a lower height than the current set transport height:
1.
Engage the return to transport height feature.
2.
Single down-tap on the center rack function switch at the desired transport height. AutoBoom will save the
current height as the new transport height.
Boom Function Switch
Center Rack Function Switch
Single Up-Tap
Single Down-Tap
Single Up-Tap
Single Down-Tap
• Disable AutoBoom control
on the boom.
• Enable AutoBoom control
on the boom.
Double Up-Tap
Double Down-Tap
Double Up-Tap
Double Down-Tap
• Raise both booms slightly.
a
a. AutoBoom systems with a single proportional valve and square coils.
• Lower both booms quickly.
• Re-enable AutoBoom
control to the set pressure
setting.
• Disable AutoBoom control
for both booms.
• Raise the center rack to the
set transport height.
• Lower the center rack to
the set target height.
• Enable AutoBoom control
for both booms.
• Raise boom slightly.
b
b. AutoBoom systems with two proportional valves and round coils.
• Lower the boom quickly.
• Re-enable AutoBoom
control to the set pressure
setting.
Four Up-Taps
Four Down-Taps
• Raise the center rack to the
maximum height.
• Turn AutoBoom system off.
• Save the maximum height
as the new transport height.
