3
Manual No. 016-0130-076 Rev. C
21
Calibration
Forward Pointing Number
(UltraGlide XT Systems Only) If an UltraGlide XT control node
is installed for automated boom height control in challenging
terrain, the system will require the node orientation to be
calibrated.
To configure the node orientation, touch and drag on the scroll
list to select the arrow on the node enclosure which is pointed
toward the front of the vehicle during normal implement
operation.
Note:
Once set during calibration, the orientation will not
be displayed by the Raven OS. To change this setting if the node orientation is physically modified,
reset the AutoBoom system calibration and recalibrate the UltraGlide XT system.
Reset Defaults
Touch the reset defaults icon in the lower, left corner of the Calibrate tab to reset the AutoBoom system
settings. Although it is not normally necessary, there may be circumstances under which it may be desired to
reset the calibration of the AutoBoom system. It is also recommended to reset system settings and recalibrate
if any significant changes are made to the tractor or implement hydraulic system.
Note:
Resetting the AutoBoom system calibration will delete all system settings and adjustments that
have been performed.
Master Power
Touch the master power icon to toggle the AutoBoom system on or off. The system must be on before
automated boom height features can be engaged during an application. Refer to the
section on page 26 for more information on enabling and engaging AutoBoom during field operations.
6
5
1
4
3
2
