PAGE 22/36 | Installation manual | 016-8000-014EN | Rev. A1
Raven Industries Inc.
STEERING SYSTEM INSTALLATION | CRX + SC1 | RAVEN EUROPE GENERIC
1.3.10
MOUNTING THE WHEEL ANGLE SENSOR
Figure 16 and Figure 17 show a detailed view of the
structure of a wheel angle sensor assembly. Table 1
also lists the components shown in Figure 16.
Symbol Description
1
Sensor housing
2
Sensor disc
3
Mounting bracket 3mm
4
Mounting strip 20x 3mm
5
2 x M5 x 16mm (countersunk
head)
6
2 x M5 x 30mm
1.
If the front wheels are straight, the screws of
the sensor housing and sensor disc should be
aligned with the front axle. It is also important
that the sensor disc is rotated in such a way
that the triangles in the disc and the sensor
housing (Figure 18) are properly aligned. Only
then will the wheel angle sensor produce a
voltage reading.
2.
The sensor housing and sensor disc should be
aligned EXACTLY on the pivot point of the stub
axle. The centre-to-centre distance of the
mounting holes is 28 mm.
Please note!:
At all times the triangles on the sensor housing
and sensor disc must be pointing in the same
direction!
TABLE 1 WHEEL ANGLE SENSOR COMPONENTS.
FIGURE 16 SCHEMATIC OVERVIEW OF WHEEL ANGLE
SENSOR WITH MOUNTING BRACKET AND STRIP
FIGURE 17 SCHEMATIC DRAWING OF WHEEL
ANGLE SENSOR WHEN MOUNTED
