PAGE 32/36 | Installation manual | 016-8000-014EN | Rev. A1
Raven Industries Inc.
GPS RECEIVER INSTALLATION | CRX + SC1 | RAVEN EUROPE GENERIC
2
GPS RECEIVER INSTALLATION
When the combination of CRx with SC1 is chosen 2
GPS receivers can be used. The 500S and 600S
INSTALLATION 500S & 600S
For connecting a 500S antenna use this adapter cable:
1-115-8000-342. For connecting a 600S use this
adapter cable: 1-115-8000-345. Look at the correct
system overview of the CRx to know which cable
should be connected with the adapter cable. If the
antenna is not connected make sure that the
connectors on the roof are provided with a protective
cap (Figure 39). With this protective cap no dust and
water can enter the connector.
For both antennas a mounting plate is available.
(Figure 35 & Figure 37)
Furthermore, the following guidelines must be
observed when installing the GPS antenna:
Mount the GPS-antenna with the connectors
pointing to the backside.
Mount the GPS-antenna in front of the rear
axle.
Hint!:
When the customer disconnects the antenna the
adapter cable should stay with the antenna.
FIGURE 37 600S ANTENNA ON MOUNTING PLATE
FIGURE 39 PROTECTIVE CAP
FIGURE 35 MOUNTING PLATE 500S
FIGURE 36 500S ANTENNA
FIGURE 38 600S ANTENNA ON MOUNTING PLATE
