STEERING SYSTEM INSTALLATION | CRX + RS1 | RAVEN EUROPE GENERIC
PAGE 13/35 | Installation manual | 016-8000-028EN | Rev. A1
If a ground switch is used in the tractor,
connect the wiring harness behind the ground
switch (not at the battery side of the ground
switch!).
If a main (12V) switch is used in the tractor, the
red wire connect the wiring harness behind the
main switch (not at the battery side of the
main switch!).
If no main switch is used, always connect the
wiring harness directly to the battery.
If the system is connected to a 24 Volt
machine, always use a 24V to 12V converter.
Never connect between the two batteries of a
24V machine!
Lead the terminal harness along with the GPS
and radio/GSM antenna cables through one
pillar of the cab.
Tie-wrap the harnesses so they are attached
free from vibration and friction.
Caution!:
It is important to ensure that the wiring harness
is always connected to the battery AFTER
installing all wires and controllers!