STEERING SYSTEM INSTALLATION | CRX + RS1 | RAVEN EUROPE GENERIC
PAGE 25/35 | Installation manual | 016-8000-028EN | Rev. A1
14.
Remove the strip again from the front axle.
Then mount the strip again to the front axle
with the aid of M5 X 30 bolts, raised with two
nuts and two washers on each side. Mount on
the correct side of the strip (Figure 25) and pay
attention to the orientation of the disc (Figure
17). The triangular marker must be on the
correct side. Make sure the the two nuts and
washer are installed on each side!
15.
Make sure the sensor magnet (Figure 26) in the
sensor disc is completely clean (no iron fillings)
before being mounted. Clean the sensor
magnet with compressed air if necessary
(Figure 27). Mount the strip back on the front
axle.
16.
Check again if the sensor disc lies under slight
pretention against the sensor housing (Figure
28). Push with your thumb to the end of the
wheel angle sensor strip to check this. The
sensor disc may only have a little bit of friction
in the sensor housing. The sensor disc should
bounce back easily and without friction (Figure
29).
Caution!:
The sensor disc should be in a fully centered
position within the sensor housing. The strip
should be able to flex in a downward direction.
FIGURE 26 DIRTY WHEEL ANGLE SENSOR MAGNET.
FIGURE 27 CLEANING WHEEL ANGLE SENSOR
MAGNET.
FIGURE 25 WHEEL ANGLE SENSOR DISC MOUNTED
WITH SPACERS.
