16
YOU HAVE NOW COMPLETED PROGRAMMING THE CONSOLE
YOU HAVE NOW COMPLETED PROGRAMMING THE CONSOLE
YOU HAVE NOW COMPLETED PROGRAMMING THE CONSOLE
YOU HAVE NOW COMPLETED PROGRAMMING THE CONSOLE
YOU HAVE NOW COMPLETED PROGRAMMING THE CONSOLE
The flashing "CAL" will now extinguish. If not, repeat procedure starting at
Step 5
. You may also wish to enter data in the key labelled: although it
is not required for the operation of the system.
8)
8)
8)
8)
8) Enter the estimated TOTAL VOLUME in TANK before you start applying product
in key labelled: Each time the tank is refilled, this number must be
re-entered.
9)
9)
9)
9)
9) To change VALVE CAL calibration number depress key labelled:
for 5
seconds. Display will flash. Enter VALVE CAL number. (See
page 13
for default
VALVE CAL settings).
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: To display operating mode (US, SI), and valve control (C-Sd, C-FC), depress
key labelled: for 5 seconds and continue holding.
2. OTHER DISPLAYS
1)
1)
1)
1)
1) To display your actual application rate, LIQ per TON, momentarily depress key
labelled:
2)
2)
2)
2)
2) To display TOTAL GRANULAR applied (lb) [kg], momentarily depress the key
labelled: To "zero out" this total at any time, enter a "0" in this key.
3)
3)
3)
3)
3) To display LIQUID VOLUME remaining in TANK (gal) [lit], momentarily depress
key labelled:
4)
4)
4)
4)
4) To display liquid TOTAL VOLUME applied, momentarily depress key labelled:
To "zero out" this total at any time, enter a "0" in this key.
5)
5)
5)
5)
5) To display liquid DAY VOLUME applied, momentarily depress key labelled:
To "zero out" this total at any time, enter a "0" in this key.
3. SELF TEST FEATURE
SELF TEST allows granular application simulation for testing the system while the
vehicle is not moving. Enter the simulated operating granular rate by depressing
the key labelled:
(display will flash). If 600 lbs/mile [kg/km] is
desired, enter 600 [600]. (See CONSOLE PROGRAMMING on
page 14
).
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: The SELF TEST feature assumes a vehicle speed of 20 MPH [km/h].
