CHAPTER
2
P/N 016-0171-675 Rev. A
5
CHAPTER 2
INTRODUCTION
SYSTEM OVERVIEW
The Raven Sidekick Pro™ ICD injection system is designed to provide accurate application of liquid chemicals
applied from an injection module. Using a separate injection module, or tank, eliminates mixing chemicals,
reduces chemical waste, and simplifies equipment care and maintenance.
After proper installation and calibration of the injection system and controller, including a set target rate for the
carrier and injected chemicals, enable the product control system and the control console system then the control
console will automatically maintain the flow regardless of vehicle speed or active boom sections.
Performance of the Raven injection system relies on proper installation of the complete sprayer system. Please
review and follow the instructions in this manual before installing and operating the system to ensure proper
setup.
INJECTION SYSTEM COMPONENTS
The Raven injection system consists of:
• Raven control console or Case Pro 700 controller
• Sidekick Pro ICD injection pump(s)
• In-line mixer
• Chemical tanks
• Plumbing components including hoses, fittings, and valves
• Brackets and hardware to fasten components to the machine
TABLE 1. Case IH Make and Model Information,
REQUIRED COMPONENTS
The following components must be installed with the Sidekick Pro ICD:
• Raven OS Version 2.8 or higher for the Viper 4+ Console or Pro 700 Console Software Version 30.
TOOLS AND MATERIALS NEEDED
The following tools are recommended for completing the installation:
Make
Model
Case IH
Trident 5550
Summary of Contents for ICD Sidekick Pro
Page 48: ...CHAPTER 5 44 ICD Sidekick Pro Injection for Case Trident Installation Manual ...
Page 57: ...P N 016 0171 675 Rev A 53 SYSTEM DIAGRAMS ...
Page 58: ...CHAPTER 6 54 ICD Sidekick Pro Injection for Case Trident Installation Manual ...
Page 60: ...INDEX 56 ICD Sidekick Pro Injection for Case Trident Installation Manual ...