Initial Machine Calibration: Initial Machine Calibration
13
INITIAL MACHINE CALIBRATION
FIGURE 4. Antenna Center Offset Screen
9. Select the value box to enter the Antenna Center Offset position.
NOTE:
The Antenna Center Offset position is measured from the centerline of the machine to the center of
the GPS antenna. A negative value should be entered if the GPS antenna is located to the left of the
centerline.
10. Select the
Next
arrow.
FIGURE 5. Antenna Height Screen
11. Select the value box to enter the Antenna Height.
NOTE:
The Antenna Height is measured from the ground to the mid-point of the GPS antenna.
12. Select the
Next
arrow.
