6
4.
MOUNTING THE CONSOLE AND CABLING
l)
l)
l)
l)
l)
Mount the Console to secure support inside the cab of the vehicle.
2)
2)
2)
2)
2)
Connect the Control Cable to the plug in the back of the Console. Route the cable
out of the vehicle cab. (Flow Meter extension cables are available from your
Dealer).
3)
3)
3)
3)
3)
Turn AUTO/MAN/OFF switch OFF and route Red and White battery wires to a 12-Volt
battery. Attach White battery wire to the NEGATIVE
NEGATIVE
NEGATIVE
NEGATIVE
NEGATIVE (-) battery terminal, and the
Red battery wire directly to the POSITIVE
POSITIVE
POSITIVE
POSITIVE
POSITIVE (+) battery terminal. See Figure 6 on
page 7. (DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER). Secure the battery
wires with plastic cable ties. DO NOT
DO NOT
DO NOT
DO NOT
DO NOT tie battery wires close to existing battery
leads or any other electrical wiring. See
Appendix 8
for Remote Switch
installation.
4)
4)
4)
4)
4)
Connect the Speed Sensor to the plug in the back of the Console.
5)
5)
5)
5)
5)
Secure and tie the Speed Sensor Cable and Console Control Cable with plastic cable
ties.
6)
6)
6)
6)
6)
Initial installation of the system is now complete.
FIGURE 5
