14
1.
INITIAL CONSOLE PROGRAMMING
When you first turn on Console power, after all installation procedures have been
completed, the Console will flash "CAL" in the RATE display. This means you must
"calibrate", or program, the Console before it can be operated. This is a one-
time operation which does not have to be repeated. Turning OFF the POWER ON/OFF
switch does not affect the Console memory. All data is retained.
IMPORTANT:
If an entry selection error is made during Steps 1-8, place the
POWER ON/OFF switch to OFF. Depress
and hold while placing
the POWER ON/OFF switch to ON. This will "reset" the Console.
The DATA display will show "US", and the RATE display will show "CAL". The
following steps must be followed:
1)
Display US (acres), SI [hectares], or TU {1000 sq. ft.}.
a)
Depressing momentarily
steps the DATA display from US to SI.
b)
Depressing momentarily
steps the DATA display from SI to TU.
c)
Depressing momentarily
steps the DATA display from TU to US.
2)
Selecting US, SI, or TU.
a)
To select US, SI, or TU, step
until the desired code is displayed
in DATA display.
b)
Momentarily depress
. The DATA display will now display SP1.
3)
Display SP1 (wheel drives, etc.) or SP2 (radar sensor).
a)
Depressing momentarily
steps the DATA display from SP1 to SP2.
b)
Depressing momentarily
steps the DATA display from SP2 to SP1.
4)
Selecting SP1 or SP2.
a)
To select SP1 or SP2, step with
until desired code is displayed in
DATA display.
b)
Momentarily depress
. The DATA display will now display LI.
Summary of Contents for SCS 660
