Ravenheat Energycatcher, Safety Instructions & Symbols Manual

Supplied By www.heating spares.co  Tel. 0161 620 6677

10

6.3

Attach the template to the wall making sure that 
the centre line is vertical using adhesive tape.

- mark the holes for the side fi xing brackets to   
  the wall as well as the centre fl ue duct, detach
  the template from the wall.
- use a 10 mm drill to make the 4 holes. Insert 
  the plastic expansion plugs.
- cut or core drill the 105 mm diameter hole for 
  inserting the fl ue duct (rear left, right or 
  vertical).
  Fix the 4 coach bolts provided, leaving them a
  couple of mm proud of the wall.
- locate the boiler fi xing stand off bracket over 
  the 4 bolts and tighten it to the wall, taking care
  not to over twist or distort the frame if the wall

is uneven.

6.1

WHEN INSTALLING ENERGYCATCHER 

IT MUST BE FITTED IN CONJUNCTION 

WITH RAVENHEAT  120/150 

CONDENSING BOILER THEREFORE ITS 

IMPORTANT TO FAMILIARISE 

YOURSELF WITH THE BOILER MANUAL 

IN CONJUNCTION WITH INSTALLATION 

OF ENERGYCATCHER.

6.2

Assembling backframe.

Select the left and right hand side stand off 
bracket, placing them face down with the fi xing 
studs facing upwards and screw holes cross 
referencing, take the 8 screws fi x the top and 
bottom cross members on the inner side of the 
side stand off brackets.

 Fig. 2

Note:
It is important to ensure screw holes line up 
correct as these have been deliberately offset 
to avoid incorrect positioning of cross members 
within the backframe assembly. 

Fig. 4.

Fix 4-15mm clips provided ( pointing clips to the 
wall )  in the backframe cross members. 

Fig. 5

Fig. 2

Fig. 3

Section  

6  INSTALLATION