RV-Z50-E Technical Manual
10
CONFIG
Show Configuration.
Display the settings of every parameter
in the unit. If the parameter is 1, then the help text is not
displayed, If the parameter is 2, the configuration is output in
strictly the format used to program another unit.
None, 1, 2
-
AESKEY
Set the AES Encryption Key
. The key length must match or
exceed the length of the encryption scheme (128/256 bit)
** indicates values that are calibrated in the factory and are unit-specific. If the “Radio Type” is changed, these
will need to be re-calibrated.
3.6
Data Communication Commands
The following commands are commands implemented by the Z50 modem for communications over a
cellular network.
Command
Command Description
Parameters
Factory
Default
ATAPN
Set APN
ATAPU
Set APN user name
ATAPP
Set APN password
ATCPIN
Set SIM card PIN number
ATPT
Enable pass-through mode and exit command mode.
Disabled
++++
Exit pass-through mode if it was operational.
ACPR
Read/Set Link Protocol
– Parameters can be one of the
following based on the desired protocol: UDP, TCP, DART
ACHN
Read/Set Hostname or IP address. Set the URL or IP
address for the link. xxxx.com or 123.45.67.89. For DART
systems, this is the hostname of the Master Gateway.
ACPN
Set/read the port number on the destination host to
communicate to.
3.7
GPS Commands
The following commands are available if the GPS option is installed.
