03/04
Model
Battery Capacity
Starting Current
Peak Current
Input
iSmart USB Output1
iSmart USB Output2
Car Cigarette LighterOutput
Net Weight (Battery Pack)
Dimensions
RP-PB053
3.2V/18000mAh/57.6Wh
300A
600A
15V/1A
5V/1.5A Max
5V/2.1A Max
12V/10A
861.6g/30.3oz
18.5x13x3cm/7.3x5.1x1.2 in
Specifications
Jump Starting Cars
Indicator
Battery Level
Unlit
0%
5 Flashing
10%
1 Solid
20%
2 Solid
40%
3 Solid
60%
4 Solid
80%
5 Solid
100%
Battery Level Indicator
1. Make sure the Cable Indicator is off. Connect the blue plug until it is fully seated inside the host.
2. Connect Red Clamp to the positive (+) battery terminal and the Black Clamp to the negative (-) battery terminal.
3. Operate following the instruction of the Cable Indicator:
4. Start the vehicle.
5. When the vehicle is started, remove the jumper cable from the vehicle battery. Leave the vehicle's engine running.
Charging the Battery Pack
There are two ways to charge the battery pack:
•
Connect the battery pack with any power outlet using a home power adapter and the 15V input port.
•
Connect the battery pack with the car cigarette lighter using the car charger cable and the 15V input port.
Charging Mobile Devices
Use any of the two USB charging ports to charge mobile devices, such as smartphones and tablets.
•
Connect the battery pack with your mobile device using the included USB cable.
•
Turn the battery pack’s power on to start charging.
LED Flashlight
Press and hold the Switch button to cycle through the different flashlight modes: ON, Warning (quick flash),SOS
(slow flash), and OFF.
Car Cigarette Lighter and USB Output
1. 12V Output: Supports most car accessories and gadgets
2. Dual 5V USB Output: Supports mobile phones, tablets, GPS navigators, etc.
Caution
1. Before jump starting the vehicle, make sure the blue plug of the jumper cable is tightly connected with the
product’s jump start socket. Otherwise, it may affect charging and even possibly cause the blue plug to melt.
2. Always check if the jumper clamps are well connected. If the vehicle battery connector is rusted or dirty, clean it
before jumping start the vehicle. DO NOT jump start again after 3 attempts. Otherwise, it will damage the host.
3. Before use, check to see if your vehicle has any other problems.
4. Connecting the two clamps together is DANGEROUS. DO NOT connect the two clamps together.
5. Disassembling the product is DANGEROUS. DO NOT disassemble the product. For repairs, please contact your
seller or ask a professional.
6. This product is not a toy and is not intended for use by children. Please do not leave the product near children
withoutadult supervision.
7. Do not allow the product to become wet or immerse it in water. Keep away from rain.
8. Do not use this product near flammable liquids, gases, or dust. Keep it away from areas with explosives.
9. Do not expose the product to heat and do not store in locations where the temperature may exceed 70 °C.
10. Recharge the product at temperatures between 0 °C and 40 °C.
11. We recommend recharging the product using only the included accessories.
12. Under extreme conditions, battery leakage may occur. Carefully wipe theliquid off using a cloth and avoid
skin contact if you notice a liquid on the batteries. In case of skin or eye contact, rinse immediately with
cleanwater and seek medical attention.
13. When discarding the product, please help us care for the environment by following your local e-waste
regulations and laws.
GREEN LIGHT on:
The
connection is correct and
the circuit is working, you
can turn on the engine to
jump start your vehicle.
RED LIGHT with buzzing
sound:
The connection is
wrong, please readjust
your clamps based on step
2 above. Wait until the
GREEN LIGHT is on to turn
on the engine.
Beep,Beep
No Lights on, no buzzing:
The vehicle's battery may
be damaged. Please
confirm the clamp
connection is correct, then
press the “BOOST” button
and wait until the GREEN
LIGHT turns on. Turn on
your engine within 30
seconds.
GREEN LIGHT blinking and
buzzing:
The vehicle
battery is low. Press the
“BOOST” button and wait
until the GREEN LIGHT
becomes solid, then turn
on the engine within 30
seconds.
Beep,Beep
