Installation Instructions for
Rayburn 216SFW Solid Fuel
and Wood Burning
Cooker
1
02/15 EINS 514410
Consumer Protection
As responsible manufacturers we take care to make sure that our products
are designed and constructed to meet the required safety standards when
properly installed and used.
IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING
WARRANTY.
Any alteration that is not approved by AGA, could
invalidate the approval of the appliance, the warranty and could also
infringe the current issue of the statutory requirements.
All local regulations including those referring to national and
European standards need to be complied with when installing this
appliance.
Control of Substances - Health & Safety
Important
This appliance may contain of the materials that are indicated below. It is
the Users/Installers responsibility to ensure that the necessary personal
protective clothing is worn when handling, where applicable, the pertinent
parts that contain any of the listed materials that could be interpreted as
being injurious to health and safety, see below for information.
Firebricks, Fuel beds, Artificial Fuels
- when handling use disposable
gloves.
Fire Cement
- when handling use disposable gloves.
Glues and Sealants
- exercise caution - if these are still in liquid form
use face mask and disposable gloves.
Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre, Kerosene
Oil
- may be harmful if inhaled, may be irritating to skin, eyes, nose and
throat. When handling avoid inhaling and contact with skin or eyes. Use
disposable gloves, face-masks and eye protection. After handling wash
hands and other exposed parts. When disposing of the product, reduce
dust with water spray, ensure that parts are securely wrapped.
WARNING
THE ASHPIT AND FIREBOX DOORS MUST BE
LOCKED CLOSED AT ALL TIMES DURING NORMAL
USE, EXCEPT WHEN LIGHTING OR RE-FUELLING
INTRODUCTION
REMEMBER: when replacing a part on this
appliance, use only spare parts that you can be
assured conform to the safety and performance that
we require. Do not use reconditioned or copy parts
that have not been clearly authorised by AGA.
The Rayburn 216SFW is intended to supply heating for:-
(a)
Cooking and domestic hot water.
(b)
Cooking, domestic hot water and central heating.
The cooker meets the requirements of BS EN 12815 :
2001 and A1 : 2014. and is fully approved under the
HETAS Ltd Approval Scheme.
Air for combustion within the firebox and the rate of
burning is determined by the manually operated
spinwheel control on the ashpit door.
This appliance has been tested using Ancit
manufactured smokeless fuel and wood logs.
The minimum clearance to combustible materials is
150mm.
Domestic Hot Water (solid fuel or wood)
When fitted for domestic hot water, the cooker will, with
normal usage in 24 hours continual burning with solid
fuel or wood provide two or three baths at intervals and
hot water for normal household requirements. The
following conditions must be fulfilled:-
1. Use only an indirect hot water storage cylinder of the
double feed type, not less than 190 litres actual
capacity, and to BS: 1566: Part 1 DF: Type 10.
2. The cylinder to be effectively lagged, and fixed
vertically.
3. The cylinder should be as near to the cooker as
possible. In no case may 1in B.S.P. or 28mm copper
flow and return pipes exceed 10m each in length.
4. 1in B.S.P. or 28mm flow and return pipes exceeding
5m each in length must be lagged.
5. The draw-off pipe to the taps must be dead-leg
connection from the expansion pipe.
Weight of appliance - 305 Kgs
The mean flue gas temperature directly downstream of
the flue spigot at nominal heat output is 295°C.
NOMINAL HEAT OUTPUT : 8.1 - 8.4 kW
TOTAL SPACE HEATING OUTPUT : 2.5 - 3.6 kW
TOTAL WATER HEATING OUTPUT : 4.8 - 5.6 kW
MINIMUM DISTANCE TO COMBUSTIBLE MATERIAL : 150mm
APPLIANCE EFFICIENCY : 72.8 - 78.4%
CO CONCENTRATION AT 13% O
2
: 0.3 - 0.51%
FLUE MASS GAS FLOW : 5.3 - 6.5 g/s
MEAN FLUE GAS TEMP : 266 - 295°C
