SEE FIG. 24
Follow instructions in section BURNER ACCESS, Steps 1
to 3 and BURNER REMOVAL, Steps 1 to 5.
1.
Isolate fuel supply.
2.
Disconnect flexible hose. (This must be replaced
annually).
3.
Remove solenoid plug.
4.
Remove feed pipe.
5.
Slacken three securing screws and remove pump.
6.
Check drive, replace if worn or damaged.
7.
Replace pump, re-assemble in reverse order.
499K ONLY - SOFT START
(SEE FIG. 25)
1.
SOFT START SOLENOID
2.
RESTRICTOR DISC
Replacement of parts (Burner)
PUMP ACCESS
Fig. 24
Fig. 25
DESN 511995
DESN 512046
PUMP
DRIVE
PUMP FIXING
SCREWS (3)
1
2
20
Summary of Contents for Heatranger 440
