SEE FIG. 34
Follow instructions in section ELECTRICAL
COMPONENT ACCESS, Steps 1 to 4.
1.
Slacken two screws at bottom of programmer.
2.
Pull the bottom of the programmer forward and lift.
3.
Replace with new programmer clip onto the hinges at
the top. Press bottom into place. Tighten two securing
screws.
To complete follow instructions in section RE-
ASSEMBLE, Steps 3 to 6.
SEE FIG. 35
Follow instructions in section ELECTRICAL
COMPONENT ACCESS, Steps 1 to 4.
1.
To remove switch from the cover panel press the two
toggles at top and bottom of switch, push switch
through panel.
2.
Push replacement switch into aperture and click into
place. The switch should be fitted with terminal 1 at the
top.
To complete follow instructions in section RE-
ASSEMBLE, Steps 3 to 6.
Replacement of parts
(Electrical controls)
26
TO FIT NEW PROGRAMMER
TO FIT NEW SELECTOR SWITCH
Fig. 34
Fig. 35
DESN 511602 A
DESN 510553 A
Summary of Contents for Heatranger 440
