The appliance must be installed on a solid level floor or base
of incombustible material which is capable of supporting the
total weight.
The location chosen for the appliance must permit installation
and the provision of a satisfactory flue and an adequate air
supply. The location must also provide space for servicing and
air circulation around the appliance.
Between wall and LH side of appliance
10mm
Between wall and RH side of appliance
10mm*
*SHOULD THE WALL PROJECT BEYOND THE FRONT OF
THE APPLIANCE, WHEN IT MUST BE INCREASED TO
50MM (SEE FIG. 1A, 1B).*
Above the raised insulating cover handle
60mm
NOTE: GAS AND WATER CONNECTIONS ARE LOCATED
ON THE LH SIDE OF THE APPLIANCE. INSTALLERS MUST
MAKE PROVISION FOR ACCESS TO THESE
CONNECTIONS DURING INSTALLATION.
In addition, adequate clearance must be available at the front
of the appliance to enable it to be operated and serviced. Flue
pipes and fittings must not be closer than 25mm to
combustible materials and where passing through a
combustible partition such as a ceiling or roof, must be
enclosed in a non-combustible sleeve providing an air space of
at least 25mm.
Spaces around flue pipes passing through walls or floors
should be sealed against the passage of smoke and flame.
Where the cooker is to stand in a recess or against a wall
which is to be tiled,
in no circumstances should the tiles
overlap the cooker top plate.
NOTE: SMOKE/SMELL EMITTED DURING INITIAL USAGE.
Some parts of the cooker have been coated with a light
covering of protective oil. During initial operation of the cooker,
this may cause smoke/smell to be emitted and is normal and
not a fault with the appliance, it is therefore advisable to open
doors and or windows to allow for ventilation. Lift the
insulating lids to prevent staining the linings.
Pipework from the meter to the appliance must be of
adequate size. It is recommended that ø22mm minimum
diameter copper tubing is used. Do not use pipes of a
smaller size than the appliance gas connection. The
complete installation must be tested for soundness and
purged in accordance with the regulations in force.
External wiring must be correctly earthed, polarised and
in accordance with current regulations. The main supply
required is 230V, 50Hz fused at 3A.
NOTE: The method of connection to the electricity supply
must facilitate complete electrical isolation of the
appliance, preferably by the use of a fused three pin plug
and unswitched shuttered outlet. Alternatively,
connection may be made by a via a fused double-pole
isolator with a contact separation of at least 3mm in all
poles and serving the appliance and system control only.
Site Requirements
LOCATION
GAS SUPPLY
ELECTRICAL SUPPLY
4
