SEE FIG. 29
Follow instructions in sections BURNER ACCESS, Steps
1 to 3, BURNER REMOVAL, Steps 1 to 5 and
DISMANTLE BURNERS Steps 1 to 3.
1.
Remove both HT leads from ignitor.
2.
Remove mains plug from ignitor.
3.
Remove 2 ignitor securing nuts and bolts.
4.
Remove ignitor.
5.
Fit new ignitor, re-assemble in reverse order.
SEE FIG. 30
Follow instructions in sections BURNER ACCESS, Steps
1 to 3, BURNER REMOVAL, Steps 1 to 5 and
DISMANTLE BURNERS Steps 1 to 3.
1.
Remove push on connections (noting position of each
connection).
2.
Slacken inner securing screw, remove outer securing
screw.
3.
Remove relay.
4.
Fit new relay, re-assemble in reverse order.
SEE FIG. 31
Follow instructions in sections BURNER ACCESS, Steps
1 to 3, BURNER REMOVAL, Steps 1 to 5 and
DISMANTLE BURNERS Steps 1 to 3.
1.
Slacken solenoid plug securing screw.
2.
Remove plug.
3.
Remove solenoid securing nut and washer.
4.
Remove solenoid coil.
5.
Fit new solenoid coil, re-assemble in reverse order.
21
Replacement of parts
(Burner)
FIG. 29
DESN 511246 ‘A’
FIG. 30
DESN 511247
FIG. 31
DESN 511248
RELAY
SOLENOID COIL
IGNITOR
Summary of Contents for Heatranger 480D
