WARNING: BEFORE REMOVING SERVICE ACCESS
COVERS OR THE OIL BURNERS ENSURE THAT ALL
ELECTRICAL SUPPLIES TO THE APPLIANCE HAVE
BEEN ISOLATED
The burners can be removed without disconnecting the
oil supply pipe. However if the filters are being cleaned or
a pressure gauge fitted to the pump then the oil supply
should be turned
OFF
and arrangements made to catch
any oil which will leak from the oil pump.
SEE FIG. 1
1.
Open up the bottom burner access door. Remove
door and put in a safe place.
2.
Remove the 4 inner panel securing screws and
remove panel.
3.
Remove the 3 plinth securing screws and remove
plinth.
4
PREPARATION
BURNER ACCESS
Burner Removal
FIG. 1
DESN 511124
Summary of Contents for Heatranger 480D
