1.
Locate thermostat phials into boiler pockets, the pump
overrun and boiler stats into the LH pocket and the
overheat stat into the RH pocket.
2.
Locate the base of the control chassis into the bottom
of the doorway aperture, tilt the chassis backwards
into position with the four screws.
3.
Thread the two wires for the selector switch through
the aperture and connect them onto the rear of the
selector switch fitted in the outer panel. Connect the
YELLOW wire on 1 and the VIOLET wire on 2.
4.
Refix the outer panel in position and secure with the 2
screws.
5.
Replace the thermostat knobs.
6.
Replace the controls door.
Replacement of parts (Electrical)
19
RE-ASSEMBLE
Summary of Contents for Heatranger 480GB
