To ensure the best performance from your Rayburn, it
should be serviced once a year, preferably at the start of
the heating season by a registered heat installer.
An additional flueway and combustion chamber clean
halfway through the heating season may be necessary in
some cases. The appliance cannot be serviced whilst hot,
so both oven and boiler thermostats should be turned off
on the evening before the service visit.
In your own interest, and that of safety to comply with
the law, all gas appliances must be installed/maintained
by a competent person, in accordance with the current
gas safety (installation and use) regulations.
Failure to install/maintain appliances correctly could lead
to prosecution.
On completion, test the gas installation for soundness.
Annual Service
BURNER REMOVAL - for cleaning and inspection.
CLEANING - Boiler heat exchanger flueways, oven and
hotplate flueways together with ceramic fibre burner
chambers.
BURNER SERVICING.
RE-COMMISSIONING.
REPLACEMENT PARTS.
INTRODUCTION
SERVICE SCHEDULE
3
Summary of Contents for Heatranger 480GB
