Follow instructions in sections BURNER ACCESS, Steps
1 to 3 and BURNER REMOVAL, Steps 1 to 6.
COOKER BURNER AND BOILER BURNER - 880K
ONLY - SEE FIG. 31
1.
Remove 3-pin plug.
2.
Remove solenoid plug.
3.
Disconnect oil pipe.
4.
Remove 4 screws and withdraw motor.
5.
Remove grub screw, slide off fan. Re-assemble in
reverse order.
NOTE:
Ensure that gaskets and seals are in place and in
good condition.
BOILER BURNER 8120 / 8150 ONLY (SEE FIG. 32)
1.
Remove 3-pin plug.
2.
Remove solenoid plug.
3.
Disconnect oil pipe.
4.
Remove 4 pozi drive screws, remove fan case inlet.
5.
Undo grub screw, remove fan.
6.
Remove 4 fixings, withdraw motor.
7.
Re-assemble in reverse order.
NOTE:
Ensure that gaskets and seals are in place and in
good condition.
Follow instructions in BURNER ACCESS, Steps 1 to 3
and BURNER NOZZLE REMOVAL, Steps 1 to 5.
SEE FIG. 33
1.
Disconnect ignition leads.
2.
Remove 2 socket head screws.
3.
Remove head assembly complete.
4.
Remove ignitor assembly by removing countersunk
screw and clamp.
5.
Fit new ignition electrode assembly, re-assemble in
reverse order.
6.
Check electrode gap and reset if necessary.
16
FAN MOTOR
FIG. 31
FIG. 32
DESN 514448
DESN 514449
FIG. 33
DESN 514447
IGNITION ELECTRODES
Replacement of parts (Burner)
