Raychem 920 Series, Installation And Operation Instruction Manual

10  

|

  nVent.com

3.4.3 Changing the Configuration

To change the controller configuration:
•  Position the desired parameter (menu item) in the display.
•  Press the   key to initiate an edit session.
•  If the console is “locked” you are prompted to enter the passcode.
•  The present setting will flash on the display to indicate that you are editing the parameter. 
•  Use the   and   keys to change the value. 
•  The operation of the   and   varies depends on the type of data being editing. See the 

following sections for details.

IMPORTANT: Once you have initiated an edit session, you must end it before switching to 

another mode or invoking another function (including switching between Points A and B). An 

edit session ends when you enter a new value (using the   key) or you back out of it (using the 

 key).

3.4.4 Changing a Non-Numeric Parameter

To change a non-numeric parameter (e.g.: an alarm mask setting):
•  Position the appropriate parameter in the display.
•  Press the   key to initiate the edit session.
•  If the console is “locked” you are prompted to enter the passcode.
•  The present setting will flash on the display to indicate that you are editing the parameter. 
•  Use   or   until the desired value appears in the display.
• Pressing  saves the new value.
• Pressing  ends the edit session without altering the parameter.

3.4.5 Changing a Numeric Parameter

To change a numeric parameter (e.g.: the control setpoint):
•  Position the appropriate parameter in the display.
•  Press the   key to initiate the edit session.
•  If the console is “locked” you are prompted to enter the passcode.
•  The present value is displayed and the last (rightmost) digit blinks. 
•  The blinking digit identifies the digit that you are editing. 
•  Use   or   to set the desired value.
•  Use   or   to move to a different digit.
•  To enter a negative value, scroll the first (leftmost) digit until a “-” appears in the display. 
• Pressing  while on the last (rightmost) digit saves the new value.
• Pressing  while on the first (leftmost) digit ends the edit session without altering the 

parameter.

3.4.6 Passcode Protection

The 920 Series Dual Point Controller provides a passcode for protection of its configuration. 

You may view any portion of the configuration with the console “locked”, however, when you 

attempt to initiate an edit session by pressing  , you are prompted to enter the passcode. 

Entering the passcode is just like entering any other numeric value; see Section 3.4.5 

“Changing a Numeric Parameter”.
Once the console is “unlocked”, you may edit any configuration parameter. The console will 

automatically re-lock after approximately five minutes of keypad inactivity, or until the user 

explicitly locks it.
IMPORTANT: Setting the programmed passcode to “0” disables passcode protection.

IMPORTANT: The console does not have to be unlocked to reset alarms.