T415 Operation & Service Manual
28
21) Crawler Front Flap Up
To raise the front flap up, press the Upper Left button on the
RH Joystick as shown on fig. 7 pg. 27 .
22) Crawler Front Flap Down
To lower the front flap down, press the Lower Left button on
the RH Joystick as shown on fig. 7 pg. 27 .
23) Parking Brake
To activate the Parking Brake press the Upper Right button
on the RH Joystick as shown on fig. 7 pg. 27. To deactivate
press the same button again. Works in conjunction with
CAN button keypad on console.
Engine Starting Conditions:
• Operator must be in Seat
• Fasten Seat belt
• Cutter Wheel Throttle Lever is Off position
• Turn Key
Warning Alarm
• Hydraulic Oil Level
• Coolant Level
• Engine Oil Pressure
• Engine Coolant Temperature
• Charge Pressure
• Accumulator Pressure
Note: These have timers that will shutdown the engine
Backup Alarm
Alarm will sound if either track drive is commanded to go
in the reverse direction (turning, spot turning or reverse)
Keypad Functions
1. Park Brake
2. Work Lights
3. Dome Light
4. Winch Out
5. Winch In
6. Wiper
7. Wiper Wash
8. Cutter Wheel Engage
9. Dome Light
10. Throttle Up
11. Throttle Down
Emergency Stop Button
The E-Stop button (12) is meant to be used to shut down
the machine in an emergency situation only. Turn button
indirection of arrow to release/reset the switch.
(Ignition)
The key switch (13) is used to start the engine, stop the
engine and activate the electrical system
• OFF
- Insert and remove the key from the switch in
this position ONLY. In the OFF position, the electrical
system is disabled.
• ON
- Turn the key to this position to enable the
electrical system. The CHECK ENGINE and WAIT
TO START warning lamps will self test for a few
seconds. When lights go out you may start the
engine.
• START
- Turn the key to this position and hold to
crank the engine. Releasing the key will allow it to
return to the ON position.
The engine will not start unless the safety interlocks are
engaged. The safety interlocks are as follows:
• Operator must be in the seat.
• Seat belt must be latched.
• Cutter Throttle is Off position.
• E-Stop Button is pulled out.
Once the engine is running, if any of these interlocks are
disengaged, the engine will remain running; however, all
machine movement will be interrupted.
Implement Engagement
The implement engagement lever (14) activates the
implement rotor or wheel. When engaging the implement,
the T415 is designed to gradually start so that a load
shock is not sent through the machine.
Be sure that the
lever is fully engaged while in operation.
Operation
fig.1
1
2
3
4
5
6
7
8
9
10
11
fig.2
13
14
12