T415 Operation & Service Manual
44
Accessing the Engine Enclosure
The Engine enclosure has 4 access doors that are lockable.
To open the engine access door, first twist open the latch.
Next, lift lever (1) to open secondary doors (2).
Simply shut the doors and twist the latch to close.
Accessing the Hydraulic Pumps
The hydraulic pumps and valves are located under the cab.
They are accessible by removing the cab mount fasteners
(3) located on each side of the cab.
Once the cab mount fasteners have been removed, use the
(4) electric motor control located inside the left front engine
enclosure door to raise/lower the cab.
Once the cab has been fully raised, insert the safety bar
(5) to hold it in the raised position. The 12V power unit is
located below the engine.
Air Cleaner - Check/Replace
To gain access to the filter cartridge, release the clips on
both sides (6), and the cover will then be free for removal.
To remove the outer filter (6A), pull on the filter and it will
slide out. To remove the inner filter(6B), pull on the filter
and it will slide out.
Completely inspect the cleanliness of both filters. If they
are slightly dirty they may be cleaned by lightly tapping on a
hard surface. Replace at stated intervals or when needed.
(Additional detail outlined in Service Section)
Air Cleaner - Ejector Valve
(If Equipped)
Discharge the rubber dust ejector valve to clean out any
trapped contaminates.
Maintenance
fig.1
1
2
fig.4
fig.2
3
4
fig.3
4
5
fig.5
6
6A
6B
