background image

Noted

After unlock, if do not do any operation, about 10 seconds, motor will be stop 

automatically. If need to quick stop after start, just re-do unlock operation.

              

Throttle/Rudder

(turn)

Throttle/Rudder

(turn)

One key unlock/landing

Front/back/Left /

right side fly rudder

Front/back/Left /

right side fly rudder

5

Environment for flight:

Distance of 3M

Distance of 2.5M

Distance of 3M

Distance of 2M

Distance of 3M

Please have good practice before go to flight

Figure2

Figure1

Battery

Battery Plug

Battery socket

7.4V1200mAh Li-po battery

USB charger

     Charger

Excluded)

Front

Front

Turn

Turn

Front

Front

Battery charging using instruction:

Headless mode operation instruction:

   When charging, please put the drone on a dry area and keep it far away from 

   heat source or explosive divices.

   After flying, please do not charge the battery if the surface temperature is still not 

   cool. Otherwise it may cause a swollen battery or even a fire hazard.

   Please make sure that you use the original adopter provided with the drone and 

   When the battery has been used for a long time, or appears to be swollen, please 

   replace them.

   If not in use for a long time will lose its charge automatically charging or 

   discharging too often may reduce its life.

Warning on Li-poly battery:

1. Battery installation: open battery door, install battery into battery socket, battery's 

    plug aim to drone's power plug, cover the battery door (Figure1).

2. Battery charging: remove the battery from drone, battery plug aim to USB adopter 

    to charge(Figure2). It will has LED red light on adopter when charge, after 240

    minutes it will be off when charge completely.

3. During the normal flight, if drone light flash rapidly, it means need to replace  

    the battery/re-charge the battery.

1. Headless mode function instruction: 

    The functioning of headless mode is pretty simple. 

    Only pre-requisite is that before taking off, 

    you’re required to position the drone in such a 

    way that its front is your front. Since yaw (the 

    left stick) anyway doesn’t have anything to do 

    with orientation(left is left and right is right all 

    the time, regardless of where your drone is pointing

    at), it is how the drone reacts to rudder(the right

    stick)that changes. In other words, even when 

    you turn your drone 90 degrees to the left.

2. How to set headless mode: 

    Base on”Reset operation introduction”third steps to reset headless mode firstly.

    Press the headless mode button after quadcopter fly. lf you don’t want to use 

    headless mode, just only press headless mode button again. 

Summary of Contents for Move Wing RD 200









Reviews: